Joint Sub-assembly
Replacement
1. Drain the power steering system fluid
2. Separate the tie rod from the steering knuckle
(1) Remove the cotter pin, loosen the groove type lock nut
(2) Separate the tie rod ball stud joint from the steering knuckle taper hole
Tie Rod RH Ball Stud Pin
Pipe
O-ring
O-ring
Band
Wire Clip
No. 2 Boot
Lock Nut
Lock Nut
No.1 Boot
Wire Clip
Band
O-ring
Joint Sub-assembly
Tie Rod LH Ball Stud Pin
137