Geely CK Series 2007 Workshop Manual page 290

II. Non-DTC Problem Inspection Table
1 With ignition switch ON (Engine Off),
the ABS warning light does not go on
[Description]
ABS Warning Light does not go
on, the likely cause may be the open in the
warning light power supply circuit, burned bulb
or damaged warning light drive module.
Check the ABS warning light
fuse in the fuse block
Ok
Remove the ECU connector,
does the warning light goes on
with the ignition switch ON?
Yes
Check whether the wire in the
ABS wire harness connecting
the ABS warning light drive
module and the ECU is short
to ground
Yes
Repair the wire harness
Burned fuse
ABS Warning Light Bulb burned
Power supply circuit open
ABS Warning Light Drive Module damaged
Abn.
Replace
No
Check whether the ABS
warning light is burned
Check whether the warn-
ing light power supply cir-
cuit and ground circuit in the
wire harness is open
Check the connector of the
warning light power supply
circuit and ground circuit in
the wire harness
Does the fault reoccur?
Replace the warning light
drive module
Likely Causes
Yes
No
Abn.
Ok
Abn.
Ok
No
Yes
Replace
Repair the wire
harness
Repair the connector
Refer to "Occa-
sional Problem
Service Key Points"
283