Geely CK Series 2007 Workshop Manual page 291

2 After the engine is started, ABS
Warning Light is normally on
[Description]
One of the Likely Causes is that
ABS warning light drive module is damaged or
there is an open in the ABS warning light
circuit.
Note: This fault only applies to the condition that the system can communicate with the scan
meter (ABS ECU Power supply is normal), and there is no DTC set.
Check whether there is an open circuit in the wire be-
tween the ECU and ABS warning light drive module
No
Check the ABS warning light drive module
Ok
Replace the ABS ECU
284
Likely Causes
The warning light drive module is damaged
ABS warning light drive module circuit open
ABS ECU is damaged
Yes
Repair the wire harness
Abn.
Replace