Table of Contents
Advertisement
Chapter 2 Starting and Charging System
I. STARTER INSPECTION
NOTICE:
These tests must be done within 5 seconds to avoid burning out the coil.
1. INSPECT MAGNETIC SWITCH
(a) Use wire to connect the starter as shown.
(b) Connect the magnetic switch and the battery as
shown.
(c) Disconnect the magnet exciting coil from the
terminal A.
(d) Check if the clutch pinion gear is moving out.
If the clutch pinion gear is not moving out, replace
the magnetic switch.
(e) Connect the battery as shown above. Disconnect
the battery positive (+) from the terminal, to make the clutch pinion gear disengaged.
(f) Check if the clutch pinion gear has returned.
If the clutch pinion gear has not returned, replace
the magnetic switch.
Section 1 Starting System
(MR479Q MR479QA MR481QA)
Terminal A
Battery
Disconnect
Battery
161
Advertisement
Table of Contents
Troubleshooting
