Section 3 Front Wheel Alignment - Geely CK Series 2007 Workshop Manual

Adjustment
1. Inspect tire
2. Inspect toe-in
Toe-in
Tire Pressure
Toe-in
If the toe-in is not as specified, adjust the tie rod (but the left and
right tie rods must be adjusted symmetrically).
3. Adjust toe-in
(1) Loose the tie rod end lock nut.
(2) Turn the left and right tie rod in the same direction for same
revolutions.
Hint: Adjust the toe-in to the specified value.
Only adjust the one-side tie rod is not allowed.
(3) Make sure the left and right tie rods are of the same length.
(The difference should be less than 0.5mm).
(4) Tighten the lock nut of tie rod.
Torque: 45~50N.m
4. Inspect wheel limited turn angle
Turn the steering wheel fully and measure the turning angle.
Wheel angle:
Inside wheel angle
Outside wheel angle
If the wheel angle is less than the specified value, check whether the length of the right and left tie rod
ends.
106

Section 3 Front Wheel Alignment

220KPa
C-D: 0±3mm
37.6°
33.3°
Front
Turn Left
Front
Inner
Outer