Geely CK Series 2007 Workshop Manual page 272

III. KEY POINTS FOR INSTALLATION
1. Pre-Check
(1) The new airbag or clock spring shall be checked before being installed.
(2) Connect negative (-) terminal cable of the battery.
(3) Connect Hi-DS T to the diagnostic interface (16 connector).
NOTICE
In case of scrapping an airbag, it shall be noted that the airbag shall be deployed according to the specified
procedures before being scrapped.
When connecting or disconnecting the Hi-DS T, turn the ignition switch OFF first.
(4) Turn the ignition switch ON.
(5) Read the diagnostic circuit and see if the other locations than the troubled area of the airbag are normal.
(6) Turn the ignition switch ON.
(7) Remove the negative (-) terminal cable from the battery, and protect it with insulating tape for insulation.
NOTICE:
Work must be started 60s after the negative (-) terminal cable is disconnected from battery.
2. Installation of clock spring: align the clock spring and install it to the
steering wheel.
Center alignment of the clock spring
Screw up the clock spring clockwise to the end, rotate it counterclock-
wise by 2.5 turns, and align it with the mark (see the figure below).
NOTICE:
If the center of the clock spring cannot be aligned, the steering wheel
will not turn midway, or cause bad performance to the clock spring
circuit, consequently hamper the normal action of the airbag.
3. Install the components of the steering wheel and airbag assembly
(1) When the center of the clock spring is aligned, install the components of the steering wheel and airbag
assembly.
(2) After being installed, rotate the left and right sides of the steering wheel to position, and make sure there
is no abnormality.
NOTICE
When installing the components of the steering wheel and airbag assembly, attention should be given to
protect the wire harness of the clock spring from seizure.
265