Allen-Bradley PowerFlex 20-comm-c FRN 1. Series User Manual page 20

2-2 Installing the Adapter
1. Set the ControlNet module's node address by rotating the node
address switches to the desired value for each digit.
Important: Each node on the ControlNet network must have a unique
address.
Important: The node address must be set before power is applied
because the module uses the node address it detects when it first receives
power. To change a node address, you must set the new value and then
remove and reapply power to or reset the module.
Figure 2.1 Setting the Module's Node Address
Setting
0-99
Description
Node address used by the adapter if switches are enabled. The default
switch setting is 02.
Important: If the address switch is set to "00", the adapter will use the setting
of Parameter 03 - [CN Addr Cfg] for the node address. Refer to
Configuring the Adapter.
2 2
3
4
1 1
0 5 0
9 9
6
7
8 8
3
4
5
6
7
Chapter 3,