Table of Contents
Advertisement
Chapter 5
CGCM-DLR Unit Startup
Recommended Equipment
120
ATTENTION: Electrostatic discharge can damage integrated circuits or
semiconductors. Follow these guidelines when you handle the module.
Touch a grounded object to discharge static potential.
•
Wear an approved wrist strap-grounding device.
•
Do not open the module or attempt to service internal components.
•
If available, use a static-safe workstation.
•
When not in use, keep the module in its static shield bag.
You need the following equipment to help in the startup of the CGCM-DLR
unit.
Programming Terminal
A suitable programming terminal (typically a notebook personal computer) with
RSLinx® software, and the Studio 5000 Logix Designer® application is required.
The programming terminal must be equipped with a suitable interface to support
communication with the Logix controller. A typical communication interface
can be a 3-port EtherNet/IP tap (catalog number 1783-ETAP) and patch cables.
Two-channel Chart Recorder or Other Suitable Data-recording
Method
A two-channel recorder or other suitable method is recommended for the
verification procedure. Chart recorder connections vary depending on the test
being performed.
Rockwell Automation Publication 1407-UM002B-EN-P - February 2019
Advertisement
Table of Contents
