Table of Contents
Advertisement
Chapter 4
CGCM-DLR Unit Configuration
80
10. Enter the following information for the new module:
a. Name: must be compliant with IEC-1131-3.
b. IP address: if you have set the IP address by using the thumbwheel
switches to 00-87 or 89-98, then select the Private Network checkbox.
c. Enter the last octet of the IP address as 1XY where X and Y are the
switch setting values. In this example, the thumbwheel switches are set
to X = 1 and Y = 4.
d. Module Definition: To edit the Module Definition (for example, major
or minor revision, electronic keying), click Change.
The Module Definition dialog box appears.
e. Make your changes and click OK to apply changes.
You return to the Module Properties dialog box.
11. To save the new module, click OK.
12. If necessary, close the Select Module Type dialog box.
Rockwell Automation Publication 1407-UM002B-EN-P - February 2019
Advertisement
Table of Contents
