Table of Contents
Advertisement
Introduction
Overview of the
Configuration Process
Preparation
CGCM-DLR Unit Configuration
This section provides a generic set-up and verification procedure for power
generation systems by using the CGCM-DLR unit and the Logix Designer
application. The various configuration parameters that are required to customize
the device to a specific application are presented. Because every application is
unique, read this section carefully and make sure that the configuration entries are
appropriate for the system being implemented.
For additional information on the Studio 5000® environment, see Logix5000™
Controllers Common Procedures, publication 1756-PM001.
Follow these steps when you use the Logix Designer application to configure the
CGCM-DLR unit.
1. Gather the necessary equipment and information.
2. Create a module.
3. Enter configuration for the module.
4. Edit configuration for a module when changes are needed.
You can record your configuration settings in the table in
suggested that you make a copy of
unit, and retain these records for future reference.
The following generator information is used to configure the CGCM-DLR unit:
• Rated frequency
• Rated voltage
• Rated current
• Rated real power
• PMG rated voltage
• Full-load exciter field voltage
• No-load exciter field voltage
• Full-load exciter field current
• Generator direct-access transient time constant T'
• Generator exciter field time constant T
• Number of main and exciter field poles
• Generator capability curve
• Generator decrement curve
Consult with the generator manufacturer to be sure that you have the correct
data.
Rockwell Automation Publication 1407-UM002B-EN-P - February 2019
Appendix F
Appendix
F, use it to record the setup for each
do
e
4
Chapter
. We
75
Advertisement
Table of Contents
