Chapter 2: Unloading The Windrower; Using Two Forklifts To Unload Windrower - MacDon M155E4 Unloading And Assembly Instructions

Chapter 2: Unloading the Windrower

You can use one or two forklifts to unload the windrower. Refer to
page 11 or 2.2 Using One Forklift to Unload Windrower, page

2.1 Using Two Forklifts to Unload Windrower

Figure 2.1: Two-Forklift Unloading Method
CAUTION
To prevent injury to bystanders and avoid striking them with machinery, do NOT allow people to stand in
the unloading area.
CAUTION
Equipment used for unloading must meet or exceed the specified requirements. Using inadequate
equipment may result in chain breakage, vehicle tipping, or machine damage.
Table 2.1 Lifting Vehicle Requirements
Minimum Lifting Capacity
Minimum Fork Length
IMPORTANT:
Forklifts are normally rated for a load located 610 mm (24 in.) ahead of the back end of the forks. To obtain forklift
capacity at 122.2 cm (48 in.), check with your forklift distributor.
1. At 122.2 cm (48 in.) from back end of forks.
214738
1
2.1 Using Two Forklifts to Unload Windrower,
13.
2500 kg (5500 lb.)
1981 mm (78 in.)
11
Revision A