Setting The Header Lower Rate (New Holland Cr/Cx Series) - MacDon FlexDraper FD1 Series Operator's Manual

1. Select HEADER RAISE RATE on the combine display.
2. Use the + or – buttons to change the setting.
3. Press ENTER to save the new setting.
NOTE:
The raise rate can be changed from 32–236 in
steps of 34. The factory setting is 100.

Setting the Header Lower Rate (New Holland CR/CX Series)

If necessary, the header lower rate (the automatic header height control button or second speed on the header
height rocker switch of the multi-function handle) can be adjusted.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator's manual for updates.
1. Select HEADER LOWER RATE on the combine
display.
2. Use the + or – buttons to change the setting to 50.
3. Press ENTER to save the new setting.
NOTE:
The lower rate can be changed from 2–247 in
steps of 7. It is factory-set to 100.
147831
OPERATION
Figure 3.296: New Holland Combine Display
Figure 3.297: New Holland Combine Display
187
Revision A