Replacing The Drive-Bay Heat Sensor Cable; Procedure; Post-Requisites - Alienware Area-51 R3 Threadripper Edition Service Manual

Replacing the drive-bay heat
sensor cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Procedure

1 Route the drive-bay heat-sensor cable through the slot on the chassis.
2 Align the tab on the drive-bay heat-sensor cable on the chassis.
3 Push the release tab on the drive-bay heat-sensor cable and press it into
place.
4 Lay the chassis on the left side.
5 Connect the drive-bay heat-sensor cable to the system board. See
board components.

Post-requisites

1 Replace the left and right side-panels. See
2 Replace the
66
stability foot.
computer. After working inside your
After working inside your
"Replacing the side
"system-
panels".