Removing The Drive-Bay Heat Sensor Cable; Prerequisites; Procedure - Alienware Area-51 R3 Threadripper Edition Service Manual

Removing the drive-bay heat
sensor cable
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.

Prerequisites

1 Remove the
2 Remove the left and right side-panels. See

Procedure

1 Lay the chassis on the right side.
2 Locate the drive-bay heat-sensor connector (SENSOR2) on the system
board. For more information on the drive-bay heat-sensor connector, see
"system-board
stability foot.
components".
computer. After working inside your
After working inside your
"Removing the side panels".
63