Save A File - Agilent Technologies ESA-E Series User Manual

Figure 2-7 Format Menu
You will see the message: Formatting Disk in the display window.
Pressing any other key after receiving the warning in step 3 on
page
5. When formatting is complete, a message, Volume A: formatted
appears on the status line. The format process takes approximately
three minutes.

Save a File

You can save files (setups, states, traces, limits, corrections, or screens)
to a floppy disk (A:\), or the internal drive (C:\). In this example you
will save a trace to the internal C: drive.
Step 1. Set up the analyzer trace
1. Turn on the 50 MHz amplitude reference signal of the analyzer.
For the Agilent E4401B and E4411B, use the 50 MHz amplitude
reference signal of the analyzer as the signal being measured. Press
Preset
For all other models, connect a cable between the front-panel
AMPTD REF OUT
Preset
Chapter 2
2-28, will abort the formatting process.
, (if present),
Factory Preset
to the analyzer
(if present),
Input/Output
File Menu Functions
,
Input/Output Amptd Ref (On)
, then press
INPUT Preset
, .
Amptd Ref Out (On)
Getting Started
.
,
Factory
2-29