Load A File - Agilent Technologies ESA-E Series User Manual

Load a file
1. Reset the analyzer by pressing
2. To access the
3. Select the type of file you want to load (setup, state, trace, limits, or
Not all file types can be loaded back into the analyzer. For example,
NOTE
Screen files and CSV (comma separated value) cannot be loaded. CSV
and Screen files are designed for use with a PC.
4. Select the directory where your file is located. In this example, select
5. Select the file you want to load into the analyzer by moving the
6. Press
Figure 2-11 File Loaded
Chapter 2
menu, press
Load
corrections). In this example you are loading a trace file; press
.
Trace
the C:\START\ directory. (Use the front-panel step keys, knob,
and/or keys to locate the directory.)
Dir Select
cursor with the front-panel knob to highlight the file name. In this
example the file is TEST1.TRC. Select the trace into which you wish
to load the file. In this example, load it into Trace 2. (
).
Trace 2
to load the specified file. Your display should look
Load Now
similar to Figure 2-11. The status bar reads: C:\START\TEST1.TRC
file loaded.
File Menu Functions
,
Preset Factory Preset
, .
File Load
Getting Started
(if present).
Type,
Dir Up,
,
Destination
2-33