Installation and Wiring
Procedure of assembly (Wiring method)
The wire end can be directly crimped without removing the wire's insulation, saving
labor.
Bend the welder (contact) back from the carrier, and set it in the pressure connection
1
tool.
Figure 49: FPΣ MIL connector assembly procedure - 1
Insert the wire without removing its insulation until it stops, and lightly grip the tool.
2
Figure 50: FPΣ MIL connector assembly procedure - 2
After press-fitting the wire, insert it into the housing.
3
Figure 51: FPΣ MIL connector assembly procedure - 3
When all wires has been inserted, fit the semi-cover into place.
4
Figure 52: FPΣ MIL connector assembly procedure - 4
5 - 18
FPΣ