NAiS FP Series User Manual page 185

Communication Function 2 General - purpose Serial Communication
Communication format setting for Micro - Imagechecker
To set the communication mode and transmission format settings for the Micro -
Imagechecker, select "5: Communication" under "5: ENVIRONMENT" on the main
menu, and set the following items.
No. Name
No. 51 Communication mode
No. 52 RS232C
Serial communication setting for Micro - Imagechecker
To enter settings relating to serial communication for the Micro - Imagechecker, select
"53: Serial Output" under "5: Communication" on "5: ENVIRONMENT" of the main
menu, and set the following items.
No. Name
No. 53 Serial Output
Tip
- If "Del" is specified for the invalid processing parameter, zero suppression
processing will be carried out on the output data, and the output format will be
changed. Always make sure "Repl. 0" is specified.
- When outputting data to an external device, numerical calculation is required, so
"Out" should be specified for the "Numerical calculation" parameter.
- When the above settings are specified, data with the contents shown below will
be output from the Micro - Imagechecker.
1 0 1 2 3 4 5
Judgment output No.2 0=NG
Judgment output No.1 1=OK
9 - 18
C R
Terminator (End code)
Results of numerical calculation No.1
Set value
Normal Mode
Baud rate . . . . . . . . . . . 9600 bps
Length . . . . . . . . . . . . . 8
Stop bit . . . . . . . . . . . . 1
Parity . . . . . . . . . . . . . . Odd
Flow Control . . . . . . . . None
Set value
Output . . . . . . . . . . . . . . 5 Column
Invalid Digit . . . . . . . . . . Repl. 0
Read End . . . . . . . . . . . None
Process End . . . . . . . . . None
Numerical Calculation . Output
Judgment . . . . . . . . . . . Output
FPΣ