NAiS FP Series User Manual page 268

FPΣ
Item No. Name
Tool 410 Unit No. setting
port port
Selection of modem connection
412
set set-
ting
413 Communication format setting
415 Communication speed (Baud rate)
setting
COM. 410 Unit No. setting
1 port 1 port
412 Communication mode setting
set-
ting
Selection of modem connection
413 Communication format setting
415 Communication speed (Baud rate)
setting
416 Starting address for received buffer of
general (serial data) communication
mode
417 Buffer capacity setting for data
received of general (serial data)
communication mode
Note
The communication format when using the PLC link is fixed at
the following settings:
the data length is 8 bits, odd parity, stop bit is 1.
The communication speed (baud rate) is fixed at 115,200 bps.
13.4 Table of System Registers
Default Descriptions
value
1 1 to 99
Disabled Enabled/Disabled
Character bit: Enter the settings for the various items.
8 bits, Character bit: 7bits/8bits
Parity check: Parity chk: none/with odd/with even
"with, odd" Stop bit: 1bit/2bits
Stop bit: 1 bit
9600 bps 2400 bps
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
1 0 to 99
Computer link Computer link
General communication
PLC link
Disabled Enabled/Disabled
Character bit: Enter the settings for the various items.
8 bits, Character bit: 7bits/8bits
Parity check: Parity chk: none/with odd/with even
"with, odd" Stop bit: 1bit/2bits
Stop bit: 1 bit The following setting is valid only when the
communication mode specified by system
register 412 has been set to "General com-
munication".
End code (Terminator): CR/CR+LF/None
Start code (Header): STX not exist/STX
exist
9600 bps 2400 bps
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
0 0 to 32764
2048 0 to 2048
13 - 19