NAiS FP Series User Manual page 307

Specifications
No. Name
Special instructions
F138 Hours, minutes
and seconds
data to seconds
data
F139 Seconds data to
hours, minutes
and seconds
data
F140 Carry flag set
F141 Carry flag reset CLC
F143 Partial I/O
update
F147 Printout
F148 Self-diagnostic
error set
F149 Message
display
F157 Time addition
F158 Time
substruction
F159 Serial data
communication
BIN arithmetic instruction
F160 Double word
(32-bit) data
square root
High - speed counter and pulse output control instructions
F0 High - speed
counter and
pulse output
control
F1 Change and
read of the
elapsed value elapsed value
of high - speed
counter
Note
The elapsed value area varies depending on the channel being
used.
13 - 58
Boolean Operand Description
HMSS S, D Converts the hour, minute and second data of (S+1, S)
to seconds data, and the converted data is stored in
(D+1, D).
SHMS S, D Converts the seconds data of (S+1, S) to hour, minute
and second data, and the converted data is stored in
(D+1, D).
STC Turns on the carry flag (R9009).
Turns off the carry flag (R9009).
IORF D1, D2 Updates the I/O from the number specified by "D1" to
the number specified by "D2".
Only possible for I/O numbers in a range of X0 to XF
and Y0 to YF.
PR S, D Converts the ASCII code data in the area starting with
"S" for printing, and outputs it to the word external out-
put relay WY specified by "D".
ERR n Stores the self-diagnostic error number "n" in DT90000
(n: K100 turns R9000 on, and turns on the ERROR/ALARM LED.
to K299)
MSG S Displays the character constant of "S" in the connected
programming tool.
CADD S1, S2, D The time after (S2+1, S2) elapses from the time of
(S1+2, S1+1, S1) is stored in (D+2, D+1, D).
CSUB S1, S2, D The time that results from subtracting (S2+1, S2) from
the time (S1+2, S1+1, S1) is stored in (D+2, D+1, D).
MTRN S, n, D This is used to send data to or receive data from an
external device through the specified COM., RS232C
or RS485 port.
DSQR S, D √(S) → (D)
MV S, Performs high- speed counter control according to the
DT90052 control code specified by "S".
DMV S, Transfers (S+1, S) to high- speed counter elapsed val-
DT90044 ue area (DT90045, DT90044). (* Note)
DT90044, Transfers value in high- speed counter elapsed value
D area (DT90045, DT90044) to (D+1, D). (* Note)
FPΣ
Steps
5
5
1
1
5
5
3
13
9
9
7
7
5
7
7