NAiS FP Series User Manual page 160

FPΣ
Setting of system register
To carry out 1:1 communication using a computer link, the system registers should be
set as shown below.
Communication format setting for FPΣ side
• Settings when using the COM. 1 port
No. Name
No. 410 Unit No. for COM.1 port
No. 412 Communication mode for COM.1 port
No. 413 Communication format for COM.1 port
No. 415 Baud rate setting for COM.1 port
• Settings when using the COM. 2 port
No. Name
No. 411 Unit No. for COM.2 port
No. 412 Communication mode for COM.2 port
No. 414 Communication format for COM.2 port
No. 415 Baud rate setting for COM.2 port
The communication format and baud rate (transmission speed) should be set to match
the connected programmable display.
Communication format setting for GT10/GT30
When the GT10/GT30 is shipped from the factory, the communication format for
GT10/GT30 settings are as shown below. "GT Configuration" settings should be
changed to match the application at hand.
Item Description
Baud rate 19200 bps
Data length 8 bits
Stop bit 1 bit (fixed)
Odd
Parity bit
8.2 Connection Example with External Device
Set value
1
Computer link
Character bit: . . . . 8 bits
Parity check: . . . . . Odd
Stop bit: . . . . . . . . . 1 bit
Terminator: . . . . . . CR
Header: . . . . . . . . . STX not exist
19200 bps
Set value
1
Computer link
Character bit: . . . . 8 bits
Parity check: . . . . . Odd
Stop bit: . . . . . . . . . 1 bit
Terminator: . . . . . . CR
Header: . . . . . . . . . STX not exist
19200 bps
next page
8 - 15