Profinet - Danfoss VLT AutomationDrive FC 360 Quick Manual

Local Control Panel and Pro...
The PROFIBUS decoupling kit contains parts that are
required for PROFIBUS to work. Install the kit after the
control cassette with PROFIBUS is installed. Illustration 5.11
and Illustration 5.12 show how to install the decoupling kit
on a frequency converter.
5 5
Illustration 5.11 Fasten the Plate with Screws
32
®
VLT AutomationDrive FC 360
1
Illustration 5.12 Push the 5-pin Connector into Place

5.6 PROFINET

FC 360 frequency converters support PROFINET. If
PROFINET is needed,
•
•
In both cases, ensure that parameter 15-43 Software Version
is higher than 1.40.
After the control cassette with PROFINET is installed, install
the PROFINET decoupling kit that is included in the control
cassette package.
To install the decoupling kit:
1.
2.
Danfoss A/S © 04/2015 All rights reserved.
Order a new frequency converter on which the
control cassette with PROFINET is pre-installed;
Order a control cassette with PROFINET (ordering
number: to replace the standard control cassette
on an existing frequency converter. In this case,
upgrade the software with MCT-10 Set-up
Software. See the Service Manual for the
instructions to upgrade the software.
Place the decoupling plate on the control
cassette that is mounted on the frequency
converter, and fasten the plate using 2 screws
(supplied), as shown in Illustration 5.13.
Tightening torque 0.7–1.0 Nm.
Push the Ethernet cable connectors into the slots
on the control cassette. Place Ethernet cables
between the spring loaded metal clamps, as
shown in Illustration 5.14, to establish mechanical
2
MG06A602