Danfoss VLT AutomationDrive FC 360 Quick Manual page 49

Diagnostics and Troubleshoo...
Symptom
Frequency limits are set incorrectly
Motor is not
reaching maximum
speed
Reference input signal not scaled
correctly
Motor speed is
Possible incorrect parameter settings
unstable
Motor runs roughly Possible overmagnetisation
Possible incorrect settings in the
Motor does not
brake parameters. Possible too short
brake
ramp-down times.
Phase-to-phase short
Open power fuses
or circuit breaker
Motor overload
trip
Loose connections
Problem with mains power (See
Mains current Alarm 4 Mains phase loss description)
imbalance greater
than 3%
Problem with the frequency
converter unit
Problem with motor or motor wiring
Motor current
imbalance greater
than 3%
Problem with the frequency
converter unit
Acoustic noise or
vibration (for
example, a fan
Resonances, for example, in the
blade is making
motor/fan system
noise or vibrations
at certain
frequencies)
Table 7.3 Troubleshooting
MG06A602
Quick Guide
Possible cause
Check output limits in
parameter 4-14 Motor Speed High Limit
[Hz] and parameter 4-19 Max Output
Frequency
Check reference input signal scaling in
6-** Analog I/O mode and parameter
group 3-1* References.
Check the settings of all motor
parameters, including all motor
compensation settings. For closed-
loop operation, check PID settings.
Check for incorrect motor settings in
all motor parameters.
Check brake parameters. Check ramp
time settings.
Motor or panel has a short phase-to-
phase. Check motor and panel phase
for shorts.
Motor is overloaded for the
application.
Perform pre-startup check for loose
connections.
Rotate input power leads into the
frequency converter 1 position: A to B,
B to C, C to A.
Rotate input power leads into the
frequency converter 1 position: A to B,
B to C, C to A.
Rotate output motor leads 1 position:
U to V, V to W, W to U.
Rotate output motor leads 1 position:
U to V, V to W, W to U.
Bypass critical frequencies by using
parameters in parameter group 4-6*
Speed Bypass.
Turn off overmodulation in
parameter 14-03 Overmodulation.
Increase resonance damping in
parameter 1-64 Resonance Dampening.
Danfoss A/S © 04/2015 All rights reserved.
Test
Program correct limits.
Program correct settings.
Check settings in parameter group 6-
** Analog I/O mode.
Check motor settings in parameter
groups 1-2* Motor data, 1-3* Adv
motor data, and 1-5* Load indep.
setting.
Check parameter group 2-0* DC brake
and 3-0* Reference limits.
Eliminate any shorts detected.
Perform the start-up test and verify
that motor current is within specifi-
cations. If motor current is exceeding
nameplate full load current, the
motor may run only with reduced
load. Review the specifications for the
application.
Tighten loose connections.
If the imbalanced leg follows the
wire, it is a power problem. Check
mains supply.
If the imbalanced leg stays on same
input terminal, it is a problem with
the unit. Contact the supplier.
If the imbalanced leg follows the
wire, the problem is in the motor or
motor wiring. Check motor and
motor wiring.
If the imbalanced leg stays on same
output terminal, it is a problem with
the unit. Contact the supplier.
Check if noise and/or vibration have
been reduced to an acceptable limit.
Solution
7
47
7