Danfoss VLT AutomationDrive FC 360 Quick Manual page 44

Application Examples
6 6
Table 6.10 Using SLC to Set a Relay
42
®
VLT AutomationDrive FC 360
Notes/comments:
If the limit in the feedback
monitor is exceeded, warning
90 feedback monitor is issued.
The SLC monitors warning 90
feedback monitor. If warning 90
feedback monitor becomes true,
relay 1 is triggered.
External equipment could
indicate that service is required.
If the feedback error goes
below the limit again within 5
s, the frequency converter
continues and the warning
disappears. But relay 1 persists
until [Off/Reset] is pressed.
Danfoss A/S © 04/2015 All rights reserved. MG06A602