Table of Contents
Advertisement
Receipt of the unit and storage
3. Receipt of the unit and storage
3.1. Reception
Keep the unit in its packaging until immediately before installation.
3.2. Transport damage
If the unit has been damaged during transport, proceed as follows:
1.
Do not proceed with the installation.
2.
Notify the distributor immediately within five days of receipt of the unit.
If ultimately you must return the unit to the manufacturer, you must use the original packaging.
3.3. Storage
Failure to follow the instructions in this section may lead to damage to the unit.
Ingeteam accepts no liability for damage resulting from the failure to follow these instructions.
If the unit is not installed immediately after reception, take into account the following points in order to avoid
damage:
•
The unit must be stored in its original packaging.
•
Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
•
Keep it away from water splashes, welding sparks, etc.
•
Cover the unit with a breathable protective material in order to prevent condensation due to ambient
humidity.
•
It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
•
Do not store the unit outdoors.
3.4. Conservation
In order to permit correct conservation of the units, they must not be removed from their original packaging until it
is time to install them.
In case of prolonged storage, the use of dry places avoiding, as far as possible, sharp changes in temperature is
recommended.
Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum conditions before
installation. Ingeteam accepts no liability in the case of failing to observe this condition.
ABI2014IQM03_ - Installation manual
Ingeteam
EN
ES
11
Advertisement
Table of Contents
