Getting started
INSTALLING THE STERILIZER
WARNING! In case of sterilizer malfunctions immediately
unplug the sterilizer and call for service. Do not attempt to
repair the sterilizer yourself.
Notice:
Please refer to technical requirements before to plug the sterilizer!
See "Diagrams" on page 117.
No other devices should be connected to the sterilizer power panel
circuit.
Put the sterilizer on a resistant, flat and level surface
1
Open the chamber door, remove all items except the chamber
2
rack from the sterilizer and close.
Remove all the plastic covers from the items.
3
Connect the used and clean water tubes on the rear.
4
Optional. Connect Ethernet cable. See "LAN connection" on the
5
previous page.
Plug the power cable into the socket in the back of the
6
sterilizer.
Place the power cable in the power cable guides.
7
Connect the power cable to a wall outlet. For power supply
8
requirements, see "Technical data" on page 115
20
Operating with the sterilizer
POWER ON/OFF THE STERILIZER
Press the power switch behind the
1
service door: the visual indicator on
the power switch will turn green.
LISA | Instructions for use | VA131 ENG Rev. 05 | 31/07/2018 | © 2018 W&H Sterilization Srl