Diagnostic
CONTENTS
This section deals with the following subjects:
Errors
Troubleshooting
Errors
CHECKS AND ACTIONS
Notice: For any error not listed in this table, call technical service.
Code
0xx
Load cannot be considered sterile. See "End of a
sterilization cycle" on page 63
Check if the main switch or network circuit breaker is OFF.
Check if the mains cable is properly connected.
Switch the sterilizer OFF and ON.
Set date and time, then switch the sterilizer OFF and ON.
Check the dust filter and ensure that the sterilizer fan is
not blocked.
10x
See error "13x to 16x" on the next page.
98
Description and actions
Repeat the cycle.
If the problem persists, call service.
Repeat the cycle.
If the problem persists, call service.
LISA | Instructions for use | VA131 ENG Rev. 05 | 31/07/2018 | © 2018 W&H Sterilization Srl
Actions
98
103