Operating The Sterilizer - W&H Lisa VA131-17 Instructions For Use Manual

INSTALLING THE STERILIZER
WARNING! In case of sterilizer malfunctions immediately
unplug the sterilizer and call for service. Do not attempt to
repair the sterilizer by yourself.
Notice:
Please ensure that all installation requirements are met before
plugging the sterilizer. See "Connection diagrams" on page 125.
No other devices should be connected to the sterilizer power panel
circuit.
Place the sterilizer on a sturdy, flat and level surface.
1
Remove all items from the sterilizer chamber except the
2
chamber rack. Remove all plastic covers from trays.
Connect the auto-fill and auto-drain tubes in the rear of the
3
sterilizer.
Connect the Ethernet cable or the Wi-Fi key in the rear of the
4
sterilizer.
Attach the power cord to the socket in the rear of the sterilizer
5
and route the cord through the cable guides.
Connect the power cord to a wall outlet. For power supply
6
requirements, see "Technical data" on page 123.
LISA | Instructions for Use | VA131 2019 ENG Rev06 | 16/04/2020 | © 2020 W&H Sterilization Srl

Operating the sterilizer

POWER THE STERILIZER ON/OFF
Press the power switch behind the
1
service door: once switched ON, the
visual indicator on the power
switch will turn green.
Getting started
21