Safety information
CONTENTS
This section deals with the following subjects:
Safety warnings
Responsibility
Safety warnings
THERMAL HAZARDS
The chamber automatically begins to heat to
n
high temperature as soon as the sterilizer is
switched on – risk of burn!
The trays and the sterilization load are hot at the
n
end of each cycle. Use tray or cassette holders
to empty the sterilization chamber.
Always wear appropriate PPE during use of the
n
sterilizer (e.g. gloves for cleaning, maintenance,
etc...).
LISA | Instructions for use | VA131 ENG Rev. 05 | 31/07/2018 | © 2018 W&H Sterilization Srl
ELECTRICAL RISKS
9
10
IMPROPER USE OF THE STERILIZER
Do not pour water or any other liquids over the
n
sterilizer (risk of electrical short circuits).
Switch off the sterilizer and unplug the mains
n
cable before inspecting, carrying out
maintenance or servicing the sterilizer.
Ensure that the power receptacle the sterilizer is
n
connected to is properly grounded.
All electric devices connected to the sterilizer
n
shall be of Insulation Class II (double insulated)
or higher.
Use only the power cord set provided by the
n
manufacturer.
The sterilizer must not be used in presence of
n
explosive or flammable gases, vapors, liquids or
solids.
The sterilizer has not been designed for the
n
sterilization of foodstuff or waste.
Do not exceed the maximum load weight limits
n
as specified in this manual (see "Sterilization
cycle management" on page 57).
Do not drink any water that has been inside the
n
sterilizer.
9