Common At Commands; Raven Leds In Circuit-Switched Mode; Step By Step Configuration - Sierra Wireless RAVEN IDEN 20070914 User Manual

Table 2-1: Example for the Raven C3211
AT*PTINIT=ATS0=1;+WS46=23;+WS45=0;+WVCLA
SS=9
Rev 3.0B Feb.08
Command

Common AT Commands

• E ‐ Echo
• Q ‐ Quiet Mode
• &C ‐ DCD Control
• &D ‐ DTR Options
• &S ‐ DSR Options
• S0 ‐ Auto‐answer mode
• S7 ‐ Wait for Carrier
• S8 Comma Pause Time
• S9 ‐ Carrier Detect Response Time

Raven LEDs in Circuit-Switched Mode

When the Raven is in Circuit‐Switched mode, the LEDs on the
front will behave differently. The Chan, Link, and Reg LEDs will
flash in tandem, like with PassThru mode, while all other
LEDs (except for Power) will be off.

Step by Step Configuration

For your convenience, these directions use a pre‐configured
template.
Circuit Switch Communications
Components
AT*PTINIT=
Include this portion only if you will not be entering
the command using a AceManager. The
remainder of the example is the command string.
AT
All AT commands must start with "AT".
S0=1;+WS46=23;+WS45=0;+WVCLASS=9
The string is a combination of AT Commands
limited to a maximum of 40 characters.
125