Table of Contents
Advertisement
Raven iDEN
102
S0=n
This register determines how the Raven responds to an
incoming TCP connection request. The Raven remains in AT
Command mode until a connection request is received. DTR
must be asserted (S211=1 or &D0) and the Raven must be set
for a successful TCP connection. The Raven will send a
"RING" string to the host. A "CONNECT" sent to the host
indicates acknowledgement of the connection request and the
TCP session is established.
•
n=0 : Off (Default).
•
n=1 : On.
•
n=2 : Use Telnet server mode on TCP connections.
•
n=3 : With a Telnet connection, overrides the clientʹs
default echo, allowing the server on the host port to
perform the echo. CRLF sequences from the telnet client
will also be edited to simply pass CRs to the server on the
host port.
S7=n
Specifies the number of seconds to wait for a TCP connection
to be established when dialing out.
•
n=seconds
S60=n
Telnet Client Echo Mode.
•
n=0 : No Echo
•
n=1 : Local Echo (Default)
•
n=2 : Remote Echo
S221=n
Connect Delay: Number of seconds to delay the "CONNECTʹ
response upon establishing a TCP connection. OR Number of
tenths of seconds to delay before outputting ENQ on the serial
port after the CONNECT when the ENQ feature is enabled
•
n=0 ‐ 255
TCPS=n
TCP connection time‐out (TCPS) units. Specifies a time interval
upon which if there is no in or outbound traffic through a TCP
connection, the connection will be terminated.
•
n=0 : minutes
•
n=1 : seconds
20070914
Advertisement
Table of Contents
