Note: The dial test should be
completed with the serial cable
disconnected to verify that no
signaling is required by the
modem.
Rev 3.0B Feb.08
Figure 2-17: HyperTerminal
4.
Enter the command: AT+WVCLASS?. Confirm
that a response of ʺ+WVCLASS: 9ʺ is returned.
5.
Enter the command: ATS0?. Confirm that a
response of ʺ001ʺ is returned.
c.
Dial the Raven modem telephone number from a land
line and verify that the modem automatically answers
the call with modem tones.
d.
Verify outgoing calls.
1.
Connect the modem to your computer with a
serial cable. Using a terminal emulation program
(HyperTerminal) set up for 9600bps, 8 data bits, no
parity and 1 stop bit.
2.
Enter the command:
[phone number], enter a known phone number
including the area code for which you can hear
ring (such as your office phone).
14. Commission the Raven Modem on
Site.
The following steps represent a guideline and makes assump‐
tions that the modem has been verified previously in a
controlled environment.
a.
Install the Raven modem verifying that all power and
antenna cables are correctly secured.
Circuit Switch Communications
. For the
ATD[phone number]
133