Raven iDEN
100
•
n=2 : Assert DSR when the modem has network coverage.
Tip: S211 can also be used to request that DSR is always asserted. If
S211 is set to 3 and &S is changed to a non-zero value, S211 will be
changed to 1.
\APPP
Set modem operation to PPP mode. Cannot be configured in
AceManager.\ASLIP
Set modem operation to SLIP mode. DTR must be asserted
(&D0 or S211=1). Cannot be configured in AceManager.
\Qn
Set or query the serial port flow control setting.
•
n=0 : No flow control is being used.
•
n=1 : RTS/CTS hardware flow control is being used.
•
n=4 : Transparent software flow control. Uses escaped
XON and XOFF for flow control. XON and XOFF
characters in data stream are escaped with the @ character
(0x40). @ in data is sent as @@.
+FCLASS=n
This command sets the Raveninto a particular fax‐mode
operation, which causes the internal hardware to process infor‐
mation presented in the Dial command in a manner suitable
for that type of information. Cannot be configured in
AceManager.
•
n=0 : Fax/data call.
•
n=8 : Normal interconnect.
+WVCLASS? queries the current setting.
+WVLASS=n
This command sets the Raven into a particular voice‐mode
operation, which causes the internal hardware to process infor‐
mation presented in the Dial command in a manner suitable
for that type of information. Cannot be configured in
AceManager.
•
n=0 : Normal interconnect (using line 1).
•
n=9 : Fax/data call.
*CTSE=n
Clear To Send Enable: This feature asserts CTS when there is a
network connection.
20070914