Table of Contents
Advertisement
Raven iDEN
96
*STATICIP=d.d.d.d
Set the static IP required to be received from the network. If the
modem does not get this IP address from the network, it will
reset the internal hardware and try again. The default is 0.0.0.0,
which allows any IP address from the network.
•
d.d.d.d=IP address
Example:
AT*STATICIP=192.168.1.23
Caution: STATICIP does not set the IP address of the modem, it
merely tells the modem which IP address to expect. If the expected IP
address is not granted while registering on the cellular network, the
modem will try to register on the network again until it receives that IP
address. If your account is set up for a dynamic IP address and you
set an address for *STATICIP, you may not be able to register on the
network at all since there is no guarantee you will receive the same
dynamic IP address again.
*STATUSCHK=n
Checks if an SMS message has been received by the modem.
•
n=1‐255 : Seconds between checks.
•
n=0 : Never check.
Serial
This group includes commands specific to general use of the
serial port.
Figure 1-4: AceManager : Serial
20070914
Advertisement
Table of Contents
