S9=N; S10=N; S23=[Speed],[Databits][Parity][Stop Bits]; S50=N - Sierra Wireless RAVEN IDEN 20070914 User Manual

Raven iDEN
98

S9=n

Specifies the time that the received carrier must be present for
the modem to recognize it and turn on Data Carrier Detect
(DCD) if applicable. The implementation is entirely at the IWF
modem. Cannot be configured in AceManager.
• n=0‐255

S10=n

Specifies the amount of time that the carrier from the remote
modem can be lost before the modem goes on‐hook. This
allows temporary disruptions to carrier without disconnecting.
A setting of 255 causes the modem to disable Carrier Detect
and presume carrier is always present. Cannot be configured
in AceManager.
• n=1‐2545

S23=[speed],[databits][parity][stop bits]

Serial line parameters. The settings take affect after reset.
• speed=300 | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 |
57600 | 115200 | 230400
• databits=7 or 8 (Databits MUST be 8 data bits for PPP
mode.)
• parity=O : Odd
• parity=E : Even
• parity=N : None
• parity=M : Mark
• stopbits=1 | 1.5 | 2
Example:
ATS23=19200,8N1
Sets modem to 19200, 8 databits, no parity, and 1 stop bit.
Tip: Can also be set using &L=[speed],[databits] [parity][stop bits]

S50=n

Data forwarding idle time‐out. If set to 0, a forwarding time‐
out of 10ms is used. Used in UDP or TCP PAD mode.
• n=tenths of a second

S51=n

PAD data forwarding character. ASCII code of character that
will cause data to be forwarded. Used in UDP or TCP PAD
mode.
20070914