Rev 3.0B Feb.08
En
Toggle AT command echo mode.
n=0 : Echo Off.
•
•
n=1 : Echo On.
Qn
The AT quiet‐mode setting. If quiet mode is set, there will be
no responses to AT commands except for data queried.
•
n=0 : Off (Default).
•
n=1 : Quiet‐mode on.
S3=n
The standard end of line character used to indicate the end of
an AT command. This character is also used as the carriage
return character for framing responses and result codes in
command state. Cannot be configured in AceManager.
•
n=0‐127 (ASCII character number)
S4=n
The standard line feed character sent by the modem to the host
at the end of a response or return code in command state.
Cannot be configured in AceManager.
•
n=0‐127 (ASCII character number)
S5=n
This register sets the character recognized as a backspace
during command entry. Cannot be configured in AceManager.
•
n=0‐127 (ASCII character number)
S6=n
This register denotes the wait time, in seconds, before a blind
dial (no dial tone detection). Cannot be configured in
AceManager.
•
n=2‐10 seconds
S8=n
Whenever a dial command contains the comma character, the
contents of this register specify the pause time for each comma.
Cannot be configured in AceManager.
•
n=0‐255
Configuration Commands
97