Tcpt=N; Enq=N; Udp; Aip=N - Sierra Wireless RAVEN IDEN 20070914 User Manual

Rev 3.0B Feb.08

TCPT=n

Interval to terminate a TCP connection when no in or
outbound traffic. This value affects only the TCP connection in
TCP PAD mode.
• n=interval
Caution: TCPT should never be 0 when using the TCP mode. A
broken TCP session can result in the modem being left with a TCP
half-open connection that can only be terminated with a reset.

*ENQ=n

Outputs an ENQ [0x05] after the TCP CONNECT delayed by
the Delay Connect Response time (S221).
• n=0 : Disabled (Default).
• n=1 : Enable ENQ on CONNECT.

UDP

This group includes commands specific to UDP serial commu‐
nications.
Figure 1-6: AceManager : UDP

AIP=n

Allow IP address.
• n=0 : Allow only the IP address specified in S53 to connect
when UDP auto answer is enabled (S82=2).
• n=1 : Allow any incoming IP address to connect when
UDP auto answer is enabled (S82=2).
Note: Always subject to any Friends filters that may be defined.
Configuration Commands
103