Raven iDEN
26
Figure 3-11: HyperTerminal : connected
Tip: You will not be prompted for a password if you connect using a
COM port.
a.
Type AT and press Enter. You should get a reply of
"OK" or "0".
b.
To see what you are typing as you type it, you will
need to turn on the echo and verbose mode. Type
ATE1V1 and press Enter.
c.
If you get a reply of "OK", then you entered the
command successfully. If you get a reply of "0" or
"ERROR", try entering the command again.
5. Enter the Master Reset Command for
iDEN
a.
Type AT*PROVISION=000000, 0123456789
b.
The Raven should respond with: "Master Reset
Succeeded". With any other response, contact TELUS
to check the account status.
c.
Press the reset button on the Raven.
The Raven should now register on the network.
20070914