Raven iDEN
90
Tip: The same information is displayed with the command S202?.
*NETSERV?
The type of service being used by the modem, for example
Tech.
*NETSTATE?
The current network state:
•
Connecting To Network: The Raven is in the process of
trying to connect to the cellular network.
•
Network Authentication Fail: Authentication to the
cellular network has failed. Verify settings to activate the
Raven.
•
Data Connection Failed: The Raven failed to connect, and
it is now waiting a set time interval before it attempts to
reconnect. Verify settings to activate the Raven.
•
Network Negotiation Fail: Network connection negoti‐
ation failed. This is usually temporary and often clears up
during a subsequent attempt.
•
Network Ready: The Raven is connected to the 1x cellular
network and ready to send data.
•
Network Dormant: The Ravenis connected to the 1x
cellular network, but the link is dormant. It will be woken
up when data is sent or received.
•
No Service: There is no cellular network detected.
•
Hardware Reset: The internal module is being reset. This
is a temporary state.
+WPNEI
The current IP address of the modem reported by the internal
module, generally obtained from TELUS. This is the address
can contact the Raven from the Internet. .
Note: If there is no current network IP address, 0.0.0.0 may be
displayed.
Information Displayed in AceManager
without AT Commands Listed
•
Bytes and Packets Received and Sent: Network traffic for
the applicable port.
20070914