Raven iDEN
132
11. Configure the Raven for your
equipment.
a.
Make any appropriate changes to the serial port
parameters to match your equipment. These changes
are made under the group Serial.
Caution: Do not under any circumstances change the
*MODEMHISPEED setting from the template configuration, the only
recommended setting to change is the S23 setting.
b.
Follow the directions above to Write the changes to the
modem.
12. Reset the Raven.
a.
Click the Disconnect button.
b.
Press the modem Reset button on the front of the
modem.
c.
Wait until the modem REG indicator is lit.
d.
Disconnect the Raven from your computer.
13. Test the Raven Configuration.
Once the modem has been activated and you've built the
command string it is recommended that the Raven modem be
tested previous to field installation.
a.
Verify that the modem Chan, Link and Reg indicators
are blinking in unison confirming that the modem is
now operating in circuit switched (IS‐95) mode.
b.
Using a terminal emulation program (HyperTerminal)
set up for 9600bps, 8 data bits, no parity and 1 stop bit,
verify the settings in the Raven.
1.
Enter the command: AT. If you do not receive a
reply of "OK", enter ATE1 to enable the echo
mode.
2.
Enter the command: AT&V
3.
Review the settings and confirm that the param‐
eters are correct:
+FCLASS=0
display to see the parameters.
+WS45=0, +WS46=23, and
. You may need to backscroll the
20070914