Rev 3.0B Feb.08
•
n=0 : Disabled (Default).
•
n=1 : Enable assertion of CTS when there is network
coverage.
RS232 voltage levels:
Positive = Network coverage.
Negative = No coverage.
Tip: Flow control (AT\Q) will override this indication, so if you want to
use CTS to indicate network coverage, flow control has to be off
(AT\Q0).
*MODEMHISPEED
Set the internal serial link speed to the internal (radio) module.
•
n=0 : 38400 (default)
•
n=1 : 115200
*NUMTOIP=n
Convert 12 digit number to IP.
•
n=0 : Use as name.
•
n=1 : Use as IP address.
*PPPNOCARRIER=n
Provides a "No Carrier" message to a device connected to the
serial port using PPP or CHAP when the cellular connection
becomes unavailable.
•
n=0 : Disabled (Default).
•
n=1 : Enabled.
TCP
This group includes commands specific to TCP serial commu‐
nications.
Figure 1-5: AceManager : TCP
Configuration Commands
101