Table of Contents
Advertisement
Rev 3.0B Feb.08
Tip: The modem should be reset upon configuring these so that the
new values will be applied. The AT*DPORT value can also be used to
specify one port (both UDP and TCP) to be forwarded.
*IDENUDPFWD=ppppp[,ppppp][,ppppp][,ppppp][,ppppp]
[,ppppp][,ppppp] [,ppppp][,ppppp][,ppppp]
Port Forwarding of custom UDP ports. Up to 10 (comma
separated) ports can be configured.
•
ppppp=port to be forwarded
Tip: The modem should be reset upon configuring these so that the
new values will be applied. The AT*DPORT value can also be used to
specify one port, both UDP and TCP, to be forwarded.
*NETMINAUTH=n
Minimum Server Authentication Mode.
•
n=0 : Accept All Authentication.
•
n=1 : CHAP Authentication.
•
n=2 : Reject Authentication.
PassThru
PassThru Mode is used to communicate directly to the Raven
internal hardware.
Caution: While the modem is in PassThru mode, ALEOS is disabled.
If you need to connect to the Raven while it is in PassThru mode, you
will need to do so with a terminal application. Not all commands are
available while the modem is in PassThru mode.
Figure 1-10: AceManager : PassThru
Configuration Commands
111
Advertisement
Table of Contents
