Snmp Parameters - Siemens CP 1515 User Manual

the field on the
tab.
For more information about DHCP refer to BOOTP and DHCP (page 231).
The field is a common parameter and must
be the same for ALL network devices within your IP subnet.
You can use either the default value (255.255.0.0) or change the subnet
mask to a value that applies in your network.
If is enabled, the subnet is also
automatically entered.
The field is an optional field that is relevant when you
intend to use the Radio Link Module support for TRAP messages (see also
SNMP Parameters (page 211)).
You can use the Default Router IP field to identify the IP address of the
router which the RLM will use to find the Trap Host IP Address (identified in
the SNMP Parameters).
The default router and the trap host IP address described later in this chapter
are only used for TRAP messages generated by the Access Point RLM upon
a reset, modification of the configuration, or forced reload procedure.
If the value of the field is set to 0.0.0.0 (default), then no
TRAP messages are initiated by this Radio Link Module.
210 Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01