To restore previously saved back-up configuration files to your Access Point
RLM proceed as follows:
1. Start the RLM Manager program.
2. Select the Radio Link Module you want to upload the configuration file
to.
3. From the Access Point RLM menu select
4. Select the configuration file you want to upload, and click
5. When prompted to confirm the upload, verify whether the pop-up
message reflects the correct IP address.
•
When the IP address value is correct, click
Access Point RLM will now reset automatically.
•
If the IP address is not correct, click
upload procedure
The new parameter settings will now be loaded into the FlashROM of the
Radio Link Module. This means that the parameters will remain intact
whenever the RLM is reset or switched off and on again. To change the
parameters again, simply repeat the procedure as described in this section
to reconfigure your RLMs.
228
Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
to proceed. The
to return to cancel the
C79000-G8976-C171-01
.
.