Table of Contents
Advertisement
You are now advised to manually modify/verify the configuration
settings of the Access Point RLM (i.e. assign a unique IP address,
setup the parameters and, (if applicable) the other Access Point
RLM identifiers such as the IP Address and SNMP passwords).
7 .
The Edit Configuration window is displayed. Note that the Edit
Configuration window does not contain an
button to upload the configuration settings to the RLM.This means that
you are editing a local configuration file and that you are not yet
connected to the RLM.
8. View (and modify) the configuration settings in all tabs.
Refer to Basic Network Configuration (page 55) for changing the
configuration settings.
9. Click the
Access Point RLM in force reload mode.
The message "Please wait while trying to connect to the RLM" appears.
While trying to connect to the Radio Link Module, the IP address in the
configuration settings is pinged.
•
Only if the IP address specified in the configuration already exists,
you are prompted to enter a new IP address. If the IP address does
not yet exists the uploading continues.
•
Because the password of the RLM in forced reload mode is always
"public" , you do not have to enter this password before uploading
information to the Access Point RLM.
10. When prompted to confirm the "Reload of the Remote System" , click
to continue.
Industrial Ethernet Wireless LAN RLM Manager, CP 1515 Manager
C79000-G8976-C171-01
button to upload the new configuration settings to the
button but an
255
Advertisement
Table of Contents
