Table of Contents
Advertisement
4.11
Updating Firmware
You can update the firmware on your panel with the TX3 Configurator software
by using one of the following methods.
•
•
The Firmware Upgrade Wizard can be used to update only one panel at a time. It
will work on any panel. This method does not work on 64-bit versions of
Windows.
The Network Firmware Upgrade procedure can update more than one panel at the
same time. In order to use the Network Firmware Upgrade, all of the panels must
already have firmware that supports this feature installed on them.
Refer to LT-995, TX3 Configuration and Administrator Manual, for instructions
on how to perform both of these firmware upgrade methods. LT-995 can be found
on the TX3 Configurator Software installation CD, USB flash drive, or on the
Mircom website.
4.11.1
Firmware Version Control
The firmware version number is accessible from the Configurator software and
changes whenever there is a major, minor or revision update.
The following convention is used whenever there is a major, minor or revision
change:
Initial release. Version 1.00.0
Major change. Version 2.00.0
Minor change. Version 2.01.0
Revision changes. Version 2.01.1
4.12
Beginning Configuration
The Lobby Control Unit controller is now ready for configuration using the USB.
An optional method is to use the RS-485 or modem connection.
For a complete description of the configuration and on how to establish a
connection to the Lobby Control Unit using USB, ethernet, RS-485, or modem,
see the following documentation:
•
66 (119)
Telephone Access System Installation and Operation Manual
LT-969
Copyright January 2017
Firmware Upgrade Wizard
Network Firmware Upgrade
LT-995 Configuration and Administration Guide
Lobby Control Unit Setup
Version 3.7
- Quick Links:
- Tx3 Systems
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers
How can the caller ID altered to show New title when a call is received ?
To alter the caller ID to show a new title on the Mircom TX3 Series, you need to edit each message line:
1. Scroll to the message line (Line-2 or Line-3).
2. Press the 1 key 9 times to enter an asterisk (*) if needed.
3. Edit the message content as desired to change the displayed title.
4. Press the telephone (enter) key to accept the changes.
5. Press the info key to return to the previous menu.
This answer is automatically generated