Table of Contents
Advertisement
Input 5. General Purpose. Input 5 is a general purpose input that, when
configured, activates a general purpose output to perform any required function.
Figure 28. Tamper Switch
4.2.4
RS-485
22 AWG twisted pair, maximum length: 4000 ft (1219.2 m)
Mircom recommends shielded cable
An RS-485 terminal lets you easily connect multiple telephone, card access and
elevator restriction controllers across a network. The RS-485 connection is
situated at the bottom middle of the main controller board and consists of two
separate terminals, each for an input and output. See Figure 29.
Panel 1
First panel on network
Optional common
reference connection
if available
Figure 29. RS-485 Connections
Telephone Access System Installation and Operation Manual
Version 3.7
LT-969
Copyright January 2017
Connect to one of
the inputs on the
entrance panel
main board to
monitor the door
closure.
120 Ω
Panel 2
Connect shield to chassis
ground on one panel only
Lobby Control Unit Setup
Panel 3
Last panel on network
120 Ω
53 (119)
- Quick Links:
- Tx3 Systems
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers
How can the caller ID altered to show New title when a call is received ?
To alter the caller ID to show a new title on the Mircom TX3 Series, you need to edit each message line:
1. Scroll to the message line (Line-2 or Line-3).
2. Press the 1 key 9 times to enter an asterisk (*) if needed.
3. Edit the message content as desired to change the displayed title.
4. Press the telephone (enter) key to accept the changes.
5. Press the info key to return to the previous menu.
This answer is automatically generated