Sony IPELA PCS-HG90 Operating Instructions Manual page 25

Notes
• If you use force to prevent the camera moving, it may not resume moving and not
output a signal to the Communication Terminal. In this case, turn off the terminal, and
turn it on again.
• When you turn on the power of the Communication Terminal for the first time after
installation, the setup wizard will appear after the self-diagnosis is completed. Set up
your system following the wizard.
For setups using the wizard, see "Setting Up the System for the First Time
— Initial Setup Wizard" on page 29.
If no picture appears on the TV monitor
The video format of the Communication Terminal is set to "1080/60i" at the
factory. If the video format set on the TV monitor is different from that on the
Communication Terminal, no picture appears on the TV monitor. Check the
video format setting on the TV monitor, and, if necessary, change the video
format setting on the Communication Terminal.
To change the video format on the Communication Terminal
Use the FAR/NEAR button and number buttons 1, 2 and 3 on the supplied
Remote Commander.
Video format to be set
1080/60i
1080/50i
720/60p
Note
When you change the Output Video Format, the system will reboot automatically.
DISPLAY VIDEO INPUT
CLEAR SYMBOL
PinP FAR/NEAR
FAR/NEAR button
BACK ALPHA/
SPACE NUM
PUSH
ENTER
RETURN MENU
CONNECT/
DISCONNECT
Number buttons 1, 2, 3
Operation
Press "FAR/NEAR", then press "1" three times.
Press "FAR/NEAR", then press "2" three times.
Press "FAR/NEAR", then press "3" three times.
Turning the System On/Off
25