Measuring The Network Quality - Sony IPELA PCS-HG90 Operating Instructions Manual

Measuring the Network Quality

This section describes how to measure the quality of the network to be used for
connection with a remote party.
The network quality measurement is possible only when the remote party uses
the PCS-HG90. You can measure the network quality in both transmitting and
receiving directions before actual connection to assure smooth communication
with the remote party.
For details on the network quality measurement setup menu, see the "Network
Quality Measurement" screen in the Administrator Setup menu (page 52).
For the network quality measurement, knowledge of the network is necessary.
Consult your network administrator or Sony dealer.
Before measurement
On the remote terminal to be measured,
the "Other Settings (Page 2/2)" screen of the Administrator Setup menu:
Measurement from Remote Site: Enabled
Test Port Number: 2253 (default value)
Administrator Setup
Other Setting
Page:
Measurement from Remote Site
Test Port Number
Note
If the usage of ports is restricted, set the port number according to the restriction. For
details, consult your network administrator or Sony dealer.
2/2
Enabled
2253
make sure that the following are set on
2005.12.28 12:34
Save Cancel
Measuring the Network Quality
71