Sony IPELA PCS-HG90 Operating Instructions Manual page 72

To start the measurement
On the local terminal that performs the measurement,
Quality Measurement (Page 1/4)" screen of the Administrator Setup menu and
operate as follows:
Administrator Setup
Network Quality Measurement
Page:
IP Address of Remote Site
Port Number of Remote Site
Maximum Bandwidth
Packet Size
1
Set up the following data.
1 IP Address of Remote Site: Enter the IP address of the remote party
you want to measure.
2 Port Number of Remote Site: Enter the port number of the remote
party you want to measure.
3 Maximum Bandwidth: Select the maximum bandwidth you want to
measure.
4 Packet Size: Enter the packet size to be used for the measurement.
2
Put a check mark on the items you want to confirm with the network
quality measurement.
1 Gateway: Default gateway
2 ping: Reachability
3 Traceroute: Network route
4 Load and Stress Test: Network condition up to the bandwidth
specified in "Maximum Bandwidth"
3
Select "Start Measurement", then press the PUSH ENTER button on the
Remote Commander.
The network quality measurement starts. "The network quality measurement is
running. Prease wait." is displayed during the measurement.
On the remote terminal being measured, "The network quality measurement is
being run by the remote party. Please wait." is displayed.
The measurement will take several minutes depending on the selected
measurement items.
When the measurement is completed, the screen changes to the "Result of
Network Quality Measurement (Page 2/4)" screen to display the measured
results.
72
Measuring the Network Quality
1/4
2253
2 Mbps
Gateway ping
Traceroute Load and Stress Test
Start Measurement
display the "Network
2005.12.28 12:34
Previous